Phison Mpall V5.13.0c -

: In MPALL, a "Red" status box usually indicates a mismatch between the firmware version and the controller, or an incorrect Flash ID setting.

Before flashing, run (if included in package) or Phison_GetInfo_v3.12.0C.exe :

While MPALL V5.13.0c is highly versatile, it is built specifically for specific generations of Phison microcontrollers. It is most commonly used with the following chips: Phison Mpall V5.13.0c

Reflashing a drive with Phison MPALL is more like working on a car engine than using a normal app. The typical workflow involves: Identification : Using a tool like ChipGenius

MPALL requires a Burner file (usually starting with BN ) and a Firmware file (starting with FW ). These must match your controller model (e.g., BN07V*.BIN and FW07V*.BIN for a PS2251-07 controller). 2. System Settings : In MPALL, a "Red" status box usually

Launch the main executable (e.g., MPALL_F1_9000.exe ) and connect your USB drive. Click the Update button to detect the device.

If the drive does not appear, your controller may require "Test Mode" (shorting pins on the physical circuit board), or the current driver configuration is blocking it. 2. Setting Up the MP.ini File The typical workflow involves: Identification : Using a

1. Run MPParamEdit_F1.exe 2. IC Type = Auto (or match controller) 3. Partition Mode = 2 (Public only) 4. Format = Tick + Low Level Format 5. Save .ini 6. Open main MPALL tool, load .ini, scan, start 7. Wait 5-10 minutes 8. Re-plug USB → fixed