The Behringer C-1 driver is a 1-inch, dual-diaphragm condenser capsule that uses a gold-sputtered Mylar diaphragm. This design allows for a wide frequency response, high sensitivity, and a low self-noise level. The driver is designed to capture a wide range of frequencies, from 20 Hz to 20 kHz, making it suitable for recording a variety of instruments and vocals.
Before troubleshooting, you must confirm exactly which microphone model you own, as their setup requirements are completely different. 1. Behringer C-1 (XLR Version) 3-pin XLR male connector. Power Requirement: Requires +48V phantom power to operate. behringer c1 driver
Go into your computer's sound settings and lower the input volume for the C-1U to around 50% - 75%. Speak naturally and adjust the slider until the audio sounds clean. 3. Audio Has a Robotic/Metallic Sound or High Latency The Behringer C-1 driver is a 1-inch, dual-diaphragm
The generic drivers that Windows installs for the C-1U work perfectly for basic recording and communication. However, if you are a musician using Digital Audio Workstations (DAWs) like Ableton Live, FL Studio, or REAPER, you might experience latency (a slight delay between when you speak into the mic and when you hear it in your headphones). Power Requirement: Requires +48V phantom power to operate
The C-1U is known for having a relatively low native output gain. Because it lacks a physical volume knob on the chassis, you must adjust it digitally.
: Some older driver packages, like the one on Softpedia that includes an ASIO2KS-Driver , are from 2009 and were specifically designed for Windows XP. Installing such an old driver on a modern Windows 10 or 11 system will likely cause problems. Stick with the modern, community-supported ASIO4ALL driver for the best results.