| Error Code | Likely Cause | Solution | |------------|--------------|----------| | (Device cannot start) | Power management conflict or corrupted firmware | Uninstall device, restart, reinstall driver. Disable USB selective suspend. | | Code 28 (Drivers not installed) | Missing driver | See Part 3 above. | | Code 43 (USB device descriptor failed) | Hardware failure or short circuit | Test on another PC. If same error, the sensor is physically dead. | | Code 45 (Not connected) | Loose internal ribbon cable (on laptops) | Open laptop and reseat the fingerprint sensor cable. |
Based on community-reported data, drives with this ID show realistic performance, though far from cutting-edge speeds. Write speeds typically average around , while read speeds are higher, ranging from 10 to 15 MB/s . For transferring documents, photos, or small MP3s, it is perfectly adequate but too slow for running an operating system or heavy applications. Usb Device Id Vid 1e3d Pid 198a
: Usually a Chipsbank CBM-series controller (e.g., CBM2093 or similar variants). Performance | Error Code | Likely Cause | Solution